| Compare 3203459 - Gas Safety Valve for Stove/Oven by Frigidaire (Rep. Y-30128-35, 774T117P10, 5303131449, 3201101, 316066400, 3131449) with Electrolux items product |
 Offer List: With Deal: $81.35 Details You save: Customers Who Seen This Item Also Compare with Microwave Oven Parts & Accessories For US/UK/DE visitors, to buy 3203459 - Gas Safety Valve for Stove/Oven by Frigidaire (Rep. Y-30128-35, 774T117P10, 5303131449, 3201101, 316066400, 3131449), please check out:    great service great prices the part was good but I ended up not needing it and my return was nice and painless good store |
| See Products Related To 3203459 - Gas Safety Valve for Stove/Oven by Frigidaire (Rep. Y-30128-35, 774T117P10, 5303131449, 3201101, 316066400, 3131449): Electrolux 3203459 - Gas Safety Valve for Stove/Oven by Frigidaire (Rep. Y-30128-35, 774T117P10, 5303131449, 3201101, 316066400, 3131449) NOTE: These valves do not fail very often. Normally the problem is with the ignitor not drawing enough amperage to open the valve. Even if the ignitor is glowing orange it is likely still the cause of the burner not igniting. Technicians refer to this as a "weak" igniter. ....DIAGNOSTIC: Remove any covers or shields and observe whether or not the burner's igniter is glowing. If the igniter is glowing but the burners has not been lit after ninety seconds, there is a high probability that the igniter is defective and will need to be replaced. If the igniter is NOT glowing the cause could be a defective safety valve, and you should test the valve for continuity (Use a multimeter to perform the test). A continuity test will determine if a continuous electrical path is present in the path. If there is no continuity, the electrical path is broken and the safety valve is defective. NOTE: These valves do not fail very often. Normally the problem is with the ignitor not drawing enough amperage to open the valve. Even if the ignitor is glowing orange it is likely still the cause of the burner not igniting. Technicians refer to this as a "weak" igniter. DIAGNOSTIC: Remove any covers or shields and observe whether or not the burner's igniter is glowing. If the igniter is glowing but the burners has not been lit after ninety seconds, there is a high probability that the igniter is defective and will need to be replaced. If the igniter is NOT glowing the cause could be a defective safety valve, and you should test the valve for continuity (Use a multimeter to perform the test). A continuity test will determine if a continuous electrical path is present in the path. If there is no continuity, the electrical path is broken and the safety valve is defective.Five Stars Hard to tell when the orfice was ready for propane use, did not want to over tighten. |
| Five Stars If you are off the grid and use propane, adjust the valve 2 1/2 turns in |